The basics of domestic door hanging are the same for almost every type of door whether it s hardwood or softwood ply flush moulded or paneled and either a normal or fire check door.
Hanging french doors margins.
Purchase door curtain panels that equal one and one half times the window width so you can gather the material when you hang it.
Tighten the screws in the hinges at the edges of the doors and at the faces.
Measure the distance between the top of the door and the bottom.
Engineered for both quality and performance this door is available in varied configurations as single double triple or quad panels.
Open both doors fully and stabilize each with a doorstop.
Nothing screams out of plumb like a new pair of badly hung french doors.
Unless you have a door set where the door is pre hung in the frame when it arrives on site then ideally the doors are hung before the architraves and door.
Measure the height and width of the french door windows.
Out of level across the rough opening measure the difference and trim the high side s jamb leg to even it out.
You already know the standard approach to hanging a door.
Choose magnetic rods and french door curtains that fit the space.
Next use a door hanger s level or a short level and long straightedge to check the rough opening for plumb.
Of course this was before we had pre hung doors.
If you are hanging the french door curtains above the doors measure the width of the french doors plus 2 inches on both sides for a total of 4 inches.
Once the doors are working properly nail the fins to the wall with nails every six to eight inches.
Measure the width of the space you want the curtain to span.
It should cover the entire window and should not block the door handle locks or hinges.
If the floor is more than 1 4 in.
Place door shims at the top and bottom hinge locations using a long level or a straight board and a short level.
Open and close the doors several times while you work your way around the edges just to make sure the doorframe hangs perfectly.
Set it in the rough opening then level shim and nail it.
If hanging the curtains to cover the panes of the doors measure the width of the pane of the glass and add 1 inch to each side for a total of 2 inches.
Set up a power or cordless drill with a screw tip attachment.
Then add the center door shims.